3GD Brake Rotor (Rear)

#GD7022

$435.48

PRODUCT FEATURES
INSTALLATION
COMPATIBILITY

- Great looks and improved stance
- Coated for corrosion resistance - wont rust!
- Maintains cooler brake temperatures
- Dimpled (not drilled) for maximum strenght
- Direct replacement for your factory rotors
- Time Required: 1 hour (approximately)
- Skill Level: Intermediate - You should have "above average" mechanical knowledge/experience to attempt this installation.
- Mustang 1979-1993 GT
- Mustang 1979-1993 LX

Collections: Brakes

Category: Brakes, Ford Mustang 1979-1993, Model_Mustang 1979-1993 GT, Model_Mustang 1979-1993 LX, Rotors: Rear, Skill_Intermediate, TimeReq_1 hour

Type: Brakes

The dimple drilled rotor was invented by EBC back in the 90's and has been imitated by many because of its ability to offer pad degassing without "Through Drilling" disc or rotor holes which has been shown to promote rotor cracks.

The wide aperture slots on the EBC units actually draw cool air under the brake pad and rotor interface and help cool the temperatures of the pad contact which can shoot up to well over 1000 degrees at the very heart of the brake pad during heavy braking and can cause brake fade or loss of brake effect. These "Full sweep" slots on the EBC Sport Brake rotor also help remove dirt dust debris and water from the braking area but without doubt the MAIN benefit of such sport rotors is their ability to maintain a flat and parallel pad surface throughout the lifetime of the brake pad set.