Ford Performance Twin 62mm Throttle Body

#M-9926-3V

$1,711.99

PRODUCT FEATURES
INSTALLATION
COMPATIBILITY

- Fits in factory location on 2005-2010 Mustang GT
- Does not include calibration, CALIBRATION REQUIRED, sold for tuner use
- Twin 62mm bore (stock Mustang GT is twin 55mm)
- CFM Rating: 1306cfm (stock dual 55mm throttle body: 953cfm)*
- Precision machined from billet aluminum to ensure consistency
- Polished finish with CNC'd Ford Racing logo
- Fully assembled complete with throttle position sensor and actuator motor, ready to bolt on!
- Uses OE gears to prevent gear bind and wear common with other aftermarket throttle bodies
- Electronic throttle control was introduced on the Mustang in 2005. It's introduction has made attention to detail and setup of replacement throttle bodies even more critical than in the past.
- Works well with Ford Racing''s M-6550-3V hot rod camshafts, M-6049-N3VPA high performance CNC ported 3V Cylinder Heads and Ford Racing's M-9424-463V performance intake manifold. Calibration Required.
All Ford Racing ETC throttle bodies feature:
- All factory sensors installed - no need to tear apart your original throttle body
- Calibrated for idle air flow using the same procedure as production throttle bodies
- Precision billet construction with tapered inlet for consistent high flow
- Polished aluminum for great looks and underhood "bling"
- Throttle body features CNC'd Ford Racing logo
- Validation through hundreds of hours of dyno, racing, and street performance driving
- Time Required: 2 hours (approximately)
- Skill Level: Intermediate - You should have "above average" mechanical knowledge/experience to attempt this installation.
- Mustang 2005-2010 GT