AEM V2 WATER/METHANOL INJECTION KIT NO TANK

#AEM30-3302

$639.37

PRODUCT FEATURES
INSTALLATION
COMPATIBILITY

- Precision Machined Billet Aluminum Injectors With Integral Check Valves
- 1 Gallon Tank With Integral Conductive Low-Fluid Sensor And Positive Lock Connector
- 20 Feet Of Injection Tubing Included. LED Dash Light For System Status And Low Fluid Warning
- Limited 1 Year Warranty
- Time Required: 5 hours (approximately)
- Skill Level: Expert - It's not recommended that you attempt this installation unless you're an experienced Technician.
- Tune Required - A custom tune file is required for use with this product.
- Universal

V2 Water/Methanol Nozzle & Controller Kit; Standard Controller; Internal MAP w/ 35psi max, 200psi WM Pump, Jets; NO TANK INCLUDED

THE AEM WATER/METHANOL INJECTION SYSTEM ADVANTAGE
Water/methanol injection for forced induction (turbocharged or supercharged) gas-powered race engines is a proven means for effectively reducing engine inlet air temperatures and suppressing harmful detonation. This allows racers to reliably increase boost and advance ignition timing without using high-octane racing fuel for power gains of up to 20%. AEM's Water/Methanol Injection Systems utilize the most robust hardware combined with more advanced features than any other comparably priced water/methanol system. Water/Methanol for All Boost Levels of Forced Induction Gas Race Engines
AEM offers two different water/methanol controller designs for gas vehicles:

One is boost dependent for forced induction vehicles up to 35 PSI of boost (kit PN 30-3300). The Boost Dependent controller has an on-board manifold absolute pressure (MAP) sensor with a molded-in nipple for a boost hose pickup.

The second controller (Kit PN 30-3350) features a multiple input design that enables users to install AEM's Water/Methanol Injection Kit on ultra-high boost vehicles (above 35 PSI) using a 0-5v voltage-based external MAP sensor.

Note: FOR OPTIMUM RESULTS, ALL WATER/METHANOL INJECTION SYSTEMS AND GAUGES SHOULD BE RUN WITH AN AEM INLINE FILTER (AEM PART #30-3003)