Ford Performance Twin 62mm Throttle Body

By: Ford Racing


    • Fits in factory location on 2005-2010 Mustang GT
    • Does not include calibration, CALIBRATION REQUIRED, sold for tuner use
    • Twin 62mm bore (stock Mustang GT is twin 55mm)
    • CFM Rating: 1306cfm (stock dual 55mm throttle body: 953cfm)*
    • Precision machined from billet aluminum to ensure consistency
    • Polished finish with CNC'd Ford Racing logo
    • Fully assembled complete with throttle position sensor and actuator motor, ready to bolt on!
    • Uses OE gears to prevent gear bind and wear common with other aftermarket throttle bodies
    • Electronic throttle control was introduced on the Mustang in 2005. It's introduction has made attention to detail and setup of replacement throttle bodies even more critical than in the past.  
    • Works well with Ford Racing''s M-6550-3V hot rod camshafts, M-6049-N3VPA high performance CNC ported 3V Cylinder Heads and Ford Racing's M-9424-463V performance intake manifold. Calibration Required.

    All Ford Racing ETC throttle bodies feature:

    • All factory sensors installed - no need to tear apart your original throttle body
    • Calibrated for idle air flow using the same procedure as production throttle bodies
    • Precision billet construction with tapered inlet for consistent high flow
    • Polished aluminum for great looks and underhood "bling"
    • Throttle body features CNC'd Ford Racing logo 
    • Validation through hundreds of hours of dyno, racing, and street performance driving
    • Time Required: 2 hours (approximately)

    • Skill Level: Intermediate - You should have "above average" mechanical knowledge/experience to attempt this installation.

    • Mustang 2005-2010 GT

Add to Wishlist

Related Items